- Jun 04, 2018
-
-
Jack Lloyd authored
Reviewed-by: Richard Levitte <levitte@openssl.org> Reviewed-by: Matt Caswell <matt@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6386)
-
Jack Lloyd authored
Address issue #5670 Reviewed-by: Richard Levitte <levitte@openssl.org> Reviewed-by: Matt Caswell <matt@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6386)
-
- Jun 03, 2018
-
-
Andy Polyakov authored
Biggest part, ~7%, of improvement resulted from omitting constants' table index increment in each round. And minor part from rescheduling instructions. Apparently POWER9 (and POWER8) manage to dispatch instructions more efficiently if they are laid down as if they have no latency... Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6406)
-
Andy Polyakov authored
This comes at cost of minor 2.5% regression on G4, which is reasonable trade-off. [Further improve compliance with ABI requirements.] Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6406)
-
Andy Polyakov authored
As it turns out originally published results were skewed by "turbo" mode. VM apparently remains oblivious to dynamic frequency scaling, and reports that processor operates at "base" frequency at all times. While actual frequency gets increased under load. Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6406)
-
Andy Polyakov authored
OPENSSL_memcmp is a must in GCM decrypt and general-purpose loop takes quite a portion of execution time for short inputs, more than GHASH for few-byte inputs according to profiler. Special 16-byte case takes it off top five list in profiler output. Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6312)
-
Andy Polyakov authored
On contemporary platforms assembly GHASH processes multiple blocks faster than one by one. For TLS payloads shorter than 16 bytes, e.g. alerts, it's possible to reduce hashing operation to single call. And for block lengths not divisible by 16 - fold two final calls to one. Improvement is most noticeable with "reptoline", because call to assembly GHASH is indirect. Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6312)
-
Andy Polyakov authored
Even though calls can be viewed as styling improvement, they do come with cost. It's not big cost and shows only on short inputs, but it is measurable, 2-3% on some platforms. Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6312)
-
Kurt Roeckx authored
Reviewed-by: Andy Polyakov <appro@openssl.org> GH: #6405
-
Kurt Roeckx authored
Only Linux and FreeBSD provide getrandom(), but they both also provide getentropy() since the same version and we already tried to call that. Reviewed-by: Andy Polyakov <appro@openssl.org> GH: #6405
-
Kurt Roeckx authored
This will actually support most OSs, and at least adds support for Solaris and OSX Fixes: #6403 Reviewed-by: Andy Polyakov <appro@openssl.org> GH: #6405
-
Kurt Roeckx authored
Reviewed-by: Andy Polyakov <appro@openssl.org> GH: #6405
-
- Jun 02, 2018
-
-
Ken Goldman authored
ECDSA_SIG_new() returns NULL on error. Reviewed-by: Matthias St. Pierre <Matthias.St.Pierre@ncp-e.com> Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6398)
-
Rich Salz authored
Reviewed-by: Richard Levitte <levitte@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6404)
-
- Jun 01, 2018
-
-
Richard Levitte authored
This includes a quick recommendation on how to name loader docmentation. Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6350)
-
- May 31, 2018
-
-
Richard Levitte authored
Just because an engine implements algorithm methods, that doesn't mean it also implements the ASN1 method. Therefore, be careful when looking for an ASN1 method among all engines, don't try to use one that doesn't exist. Fixes #6381 Reviewed-by: Tim Hudson <tjh@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6383) (cherry picked from commit 1ac3cd6277f880fac4df313702d5e3b3814e56e2) (cherry picked from commit 13b578ada3106a4ce9b836f167ee520539f5fa8f)
-
Matt Caswell authored
This is probably a "should not happen" scenario, but better check anyway. Found by Coverity. Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6373)
-
Matt Caswell authored
Found by Coverity Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6373)
-
Matt Caswell authored
Fix a memory leak in storeutl. Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6373)
-
Matt Caswell authored
Issue found by Coverity. Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6373)
-
Matt Caswell authored
This doesn't apply if we're doing DTLS, or using UNIX domain sockets. Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6373)
-
Matt Caswell authored
Fix some instances where we weren't checking the error return. Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6373)
-
Matt Caswell authored
Found by coverity. This is an artifact left over from the original decaf import which generated the source code for different curves. For curve 448 this is dead. Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6373)
-
Matt Caswell authored
Issues found by Coverity Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6373)
-
Richard Levitte authored
XN_FLAG_COMPAT has a unique property, its zero for value. This means it needs special treatment; if it has been set (which can only be determined indirectly) and set alone (*), no other flags should be set. (*) if any other nameopt flag has been set by the user, compatibility mode is blown away. Reviewed-by: Matt Caswell <matt@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6382)
-
- May 30, 2018
-
-
Yihong Wang authored
In `aes_wrap_cipher()`, the minimal out buff length is `(inlen - 8)`. Since it calls `CRYPTO_128_unwrap_pad()` underneath, it makes sense to reduce the minimal out length in `CRYPTO_128_unwrap_pad()` to align to its caller. Signed-off-by: Yihong Wang <yh.wang@ibm.com> Reviewed-by: Andy Polyakov <appro@openssl.org> Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6266)
-
User authored
The One&Done attack, which is described in a paper to appear in the USENIX Security'18 conference, uses EM emanations to recover the values of the bits that are obtained using BN_is_bit_set while constructing the value of the window in BN_mod_exp_consttime. The EM signal changes slightly depending on the value of the bit, and since the lookup of a bit is surrounded by highly regular execution (constant-time Montgomery multiplications) the attack is able to isolate the (very brief) part of the signal that changes depending on the bit. Although the change is slight, the attack recovers it successfully >90% of the time on several phones and IoT devices (all with ARM processors with clock rates around 1GHz), so after only one RSA decryption more than 90% of the bits in d_p and d_q are recovered correctly, which enables rapid recovery of the full RSA key using an algorithm (also described in the paper) that modifies the branch-and-prune approach for a situation in which the exponents' bits are recovered with errors, i.e. where we do not know a priori which bits are correctly recovered. The mitigation for the attack is relatively simple - all the bits of the window are obtained at once, along with other bits so that an entire integer's worth of bits are obtained together using masking and shifts, without unnecessarily considering each bit in isolation. This improves performance somewhat (one call to bn_get_bits is faster than several calls to BN_is_bit_set), so the attacker now gets one signal snippet per window (rather than one per bit) in which the signal is affected by all bits in the integer (rather than just the one bit). Reviewed-by: Andy Polyakov <appro@openssl.org> Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6276)
-
Andy Polyakov authored
32-bit vector rotate instruction was defined from beginning, it not being used from the start must be a brain-slip... Reviewed-by: Bernd Edlinger <bernd.edlinger@hotmail.de> Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6363)
-
Andy Polyakov authored
Reviewed-by: Bernd Edlinger <bernd.edlinger@hotmail.de> Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6363)
-
Andy Polyakov authored
Reviewed-by: Tim Hudson <tjh@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6311)
-
Andy Polyakov authored
Goal is to exercise AEAD ciphers in TLS-like sequence, i.e. 13-byte AAD followed by payload. Update doc/man1/speed.pod accordingly. [While we are at it, address even some styling and readability issues.] Reviewed-by: Tim Hudson <tjh@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6311)
-
Andy Polyakov authored
Reviewed-by: Tim Hudson <tjh@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6311)
-
Richard Levitte authored
Under a mingw shell, the command line path conversion either mangles file: URIs to something useless (file;C:\...) or not at all (which can't be opened by the Windows C RTL unless we're really lucky), so we simply skip testing them in that environment. Fixes #6369 Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6376)
-
Mingtao Yang authored
OpenSSL 1.1.0 made the X509_LOOKUP_METHOD structure opaque, so applications that were previously able to define a custom lookup method are not able to be ported. This commit adds getters and setters for each of the current fields of X509_LOOKUP_METHOD, along with getters and setters on several associated opaque types (such as X509_LOOKUP and X509_OBJECT). Reviewed-by: Matt Caswell <matt@openssl.org> Reviewed-by: Richard Levitte <levitte@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6152)
-
Dmitry Belyavskiy authored
Reviewed-by: Bernd Edlinger <bernd.edlinger@hotmail.de> Reviewed-by: Matt Caswell <matt@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6168)
-
Dmitry Belyavskiy authored
Reviewed-by: Bernd Edlinger <bernd.edlinger@hotmail.de> Reviewed-by: Matt Caswell <matt@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6168)
-
Dmitry Belyavskiy authored
Reviewed-by: Bernd Edlinger <bernd.edlinger@hotmail.de> Reviewed-by: Matt Caswell <matt@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6168)
-
- May 29, 2018
-
-
Todd Short authored
It's freed with OPENSSL_free() Reviewed-by: Andy Polyakov <appro@openssl.org> Reviewed-by: Matt Caswell <matt@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6331)
-
Todd Short authored
Return immediately upon discovery of bad message digest. Reviewed-by: Andy Polyakov <appro@openssl.org> Reviewed-by: Matt Caswell <matt@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6298)
-
Matt Caswell authored
Check all functions that do this. Reviewed-by: Rich Salz <rsalz@openssl.org> (Merged from https://github.com/openssl/openssl/pull/6355)
-