Skip to content
CHANGES 289 KiB
Newer Older
 OpenSSL CHANGES
 Changes between 0.9.7a and 0.9.8  [xx XXX xxxx]
Bodo Möller's avatar
Bodo Möller committed

  *) Various fixes to base64 BIO and non blocking I/O. On write 
     flushes were not handled properly if the BIO retried. On read
     data was not being buffered properly and had various logic bugs.
     [Steve Henson]

  *) Support for single pass processing for S/MIME signing. This now
     means that S/MIME signing can be done from a pipe, in addition
     cleartext signing (multipart/signed type) is effectively streaming
     and the signed data does not need to be all held in memory.

     This is done with a new flag PKCS7_PARTSIGN. When this flag is set
     PKCS7_sign() only initializes the PKCS7 structure and the actual signing
     is done after the data is output (and digests calculated) in
     SMIME_write_PKCS7().
     [Steve Henson]

  *) Add full support for -rpath/-R, both in shared libraries and
     applications, at least on the platforms where it's known how
     to do it.
     [Richard Levitte]

  *) In crypto/ec/ec_mult.c, implement fast point multiplication with
Bodo Möller's avatar
Bodo Möller committed
     precomputation, based on wNAF splitting: EC_GROUP_precompute_mult()
     will now compute a table of multiples of the generator that
Bodo Möller's avatar
Bodo Möller committed
     makes subsequent invocations of EC_POINTs_mul() or EC_POINT_mul()
     faster (notably in the case of a single point multiplication,
     scalar * generator).
     [Nils Larsch, Bodo Moeller]

  *) IPv6 support for certificate extensions. The various extensions
     which use the IP:a.b.c.d can now take IPv6 addresses using the
     formats of RFC1884 2.2 . IPv6 addresses are now also displayed
     correctly.
     [Steve Henson]

  *) Added an ENGINE that implements RSA by performing private key
     exponentiations with the GMP library. The conversions to and from
     GMP's mpz_t format aren't optimised nor are any montgomery forms
     cached, and on x86 it appears OpenSSL's own performance has caught up.
     However there are likely to be other architectures where GMP could
     provide a boost. This ENGINE is not built in by default, but it can be
     specified at Configure time and should be accompanied by the necessary
     linker additions, eg;
         ./config -DOPENSSL_USE_GMP -lgmp
     [Geoff Thorpe]

  *) "openssl engine" will not display ENGINE/DSO load failure errors when
     testing availability of engines with "-t" - the old behaviour is
     produced by increasing the feature's verbosity with "-tt".
     [Geoff Thorpe]

  *) ECDSA routines: under certain error conditions uninitialized BN objects
     could be freed. Solution: make sure initialization is performed early
     enough. (Reported and fix supplied by Nils Larsch <nla@trustcenter.de>
     via PR#459)
     [Lutz Jaenicke]

  *) Key-generation can now be implemented in RSA_METHOD, DSA_METHOD
     and DH_METHOD (eg. by ENGINE implementations) to override the normal
     software implementations. For DSA and DH, parameter generation can
     also be overriden by providing the appropriate method callbacks.
     [Geoff Thorpe]

  *) Change the "progress" mechanism used in key-generation and
     primality testing to functions that take a new BN_GENCB pointer in
     place of callback/argument pairs. The new API functions have "_ex"
     postfixes and the older functions are reimplemented as wrappers for
     the new ones. The OPENSSL_NO_DEPRECATED symbol can be used to hide
     declarations of the old functions to help (graceful) attempts to
     migrate to the new functions. Also, the new key-generation API
     functions operate on a caller-supplied key-structure and return
     success/failure rather than returning a key or NULL - this is to
     help make "keygen" another member function of RSA_METHOD etc.

     Example for using the new callback interface:

          int (*my_callback)(int a, int b, BN_GENCB *cb) = ...;
          void *my_arg = ...;
          BN_GENCB my_cb;

          BN_GENCB_set(&my_cb, my_callback, my_arg);

          return BN_is_prime_ex(some_bignum, BN_prime_checks, NULL, &cb);
          /* For the meaning of a, b in calls to my_callback(), see the
           * documentation of the function that calls the callback.
           * cb will point to my_cb; my_arg can be retrieved as cb->arg.
           * my_callback should return 1 if it wants BN_is_prime_ex()
           * to continue, or 0 to stop.
           */

  *) Change the ZLIB compression method to be stateful, and make it
     available to TLS with the number defined in 
     draft-ietf-tls-compression-04.txt.
     [Richard Levitte]

  *) Add the ASN.1 structures and functions for CertificatePair, which
     is defined as follows (according to X.509_4thEditionDraftV6.pdf):

     CertificatePair ::= SEQUENCE {
        forward		[0]	Certificate OPTIONAL,
        reverse		[1]	Certificate OPTIONAL,
        -- at least one of the pair shall be present -- }

     Also implement the PEM functions to read and write certificate
     pairs, and defined the PEM tag as "CERTIFICATE PAIR".

     This needed to be defined, mostly for the sake of the LDAP
     attribute crossCertificatePair, but may prove useful elsewhere as
     well.
     [Richard Levitte]

  *) Make it possible to inhibit symlinking of shared libraries in
     Makefile.shared, for Cygwin's sake.
     [Richard Levitte]

  *) Extend the BIGNUM API by creating new macros that behave like
     functions

          void BN_set_sign(BIGNUM *a, int neg);
          int BN_get_sign(const BIGNUM *a);

     and avoid the need to access 'a->neg' directly in applications.
     [Nils Larsch  <nla@trustcenter.de>]

  *) Implement fast modular reduction for pseudo-Mersenne primes
     used in NIST curves (crypto/bn/bn_nist.c, crypto/ec/ecp_nist.c).
     EC_GROUP_new_curve_GFp() will now automatically use this
     if applicable.
     [Nils Larsch <nla@trustcenter.de>]

  *) Add new lock type (CRYPTO_LOCK_BN).
     [Bodo Moeller]

  *) Change the ENGINE framework to automatically load engines
     dynamically from specific directories unless they could be
     found to already be built in or loaded.  Move all the
     current engines except for the cryptodev one to a new
     directory engines/.
     The engines in engines/ are built as shared libraries if
     the "shared" options was given to ./Configure or ./config.
     Otherwise, they are inserted in libcrypto.a.
     /usr/local/ssl/engines is the default directory for dynamic
     engines, but that can be overriden at configure time through
     the usual use of --prefix and/or --openssldir, and at run
     time with the environment variable OPENSSL_ENGINES.
     [Geoff Thorpe and Richard Levitte]

  *) Add Makefile.shared, a helper makefile to build shared
     libraries.  Addapt Makefile.org.
     [Richard Levitte]

Dr. Stephen Henson's avatar
 
Dr. Stephen Henson committed
  *) Add version info to Win32 DLLs.
     [Peter 'Luna' Runestig" <peter@runestig.com>]

Dr. Stephen Henson's avatar
 
Dr. Stephen Henson committed
  *) Add new 'medium level' PKCS#12 API. Certificates and keys
     can be added using this API to created arbitrary PKCS#12
     files while avoiding the low level API.

     New options to PKCS12_create(), key or cert can be NULL and
     will then be omitted from the output file. The encryption
     algorithm NIDs can be set to -1 for no encryption, the mac
     iteration count can be set to 0 to omit the mac.

     Enhance pkcs12 utility by making the -nokeys and -nocerts
     options work when creating a PKCS#12 file. New option -nomac
     to omit the mac, NONE can be set for an encryption algorithm.
     New code is modified to use the enhanced PKCS12_create()
     instead of the low level API.
     [Steve Henson]

  *) Extend ASN1 encoder to support indefinite length constructed
     encoding. This can output sequences tags and octet strings in
     this form. Modify pk7_asn1.c to support indefinite length
     encoding. This is experimental and needs additional code to
     be useful, such as an ASN1 bio and some enhanced streaming
     PKCS#7 code.

     Extend template encode functionality so that tagging is passed
     down to the template encoder.
     [Steve Henson]

  *) Let 'openssl req' fail if an argument to '-newkey' is not
     recognized instead of using RSA as a default.
     [Bodo Moeller]

Bodo Möller's avatar
Bodo Möller committed
  *) Add support for ECC-based ciphersuites from draft-ietf-tls-ecc-01.txt.
     As these are not official, they are not included in "ALL";
     the "ECCdraft" ciphersuite group alias can be used to select them.
     [Vipul Gupta and Sumit Gupta (Sun Microsystems Laboratories)]

Bodo Möller's avatar
Bodo Möller committed
  *) Add ECDH engine support.
     [Nils Gura and Douglas Stebila (Sun Microsystems Laboratories)]
Loading full blame...