the first.

found by Michal Marek.

Disable valgrind in test case 1004 due to a libtool bug.

Tests 35, 544 545 added: binary data POSTs.

to running it and ignoring its output).

lib is built shared with libtool.

Added test cases 2002 and 2003 (the latter disabled for now)

same easy handle
Fixed the filecheck: make target to work outside the source tree

when assigning a NULL pointer to a function pointer var.

Added support for skipping tests based on key words.

risk of failures.

This happened because the tftp code always uncondionally did a bind()
without caring if one already had been done and then it failed. I wrote a
test case (1009) to verify this, but it is a bit error-prone since it will
have to pick a fixed local port number and since the tests are run on so
many different hosts in different situations I add it in disabled state.

Added test case 1008 to verify. Note that #47 is still there.

attempt to force smaller bits to get read by clients.

target called 'filecheck' so that if you run 'make filecheck' in this directory
it'll check if the local files are also mentioned in the Makefile.am so that
they are properly included in release archives!

function do wrong on all input bytes that are >= 0x80 (decimal 128) due to a
signed / unsigned mistake in the code. I fixed it and added test case 543 to
verify.

variables to avoid shadowing global declarations.

curl_easy_setopt() that alters how libcurl functions when following
redirects. It makes libcurl obey the RFC2616 when a 301 response is received
after a non-GET request is made. Default libcurl behaviour is to change
method to GET in the subsequent request (like it does for response code 302
- because that's what many/most browsers do), but with this CURLOPT_POST301
option enabled it will do what the spec says and do the next request using
the same method again. I.e keep POST after 301.

The curl tool got this option as --post301

Test case 1011 and 1012 were added to verify.

CURLOPT_NOBODY enabled but not CURLOPT_HEADER, libcurl wouldn't do TYPE
before it does SIZE which makes it less useful. I walked over the code and
made it do this properly, and added test case 542 to verify it.

URLs ending with a slash properly (it should list the contents of that
directory). Test case 351 brought back and also test 1010 was added.

Made a few more tests work remotely.