on Solaris)

It's still totally untested ...

Submitted by: Lennart Bang

I've chosen to nest two functions in order to save about 4K. As a result
s1-win32.asm doesn't look right (nested PROC/ENDP SEGMENT/ENDS) and it's
probably impossible to compile. I assume I have to reconsider... But not
today...

"Clean-up" stands for the fact that it's using common message digest
template ../md32_common.h and sha[1_]dgst.c are reduced down to
'#define SHA_[01]' and then '#include "sha_locl.h"'. It stands "(LP64)"
there because it's 64 bit platforms which benefit most from the tune-up.
The updated code exhibits 40% performance improvement on IRIX64
(sounds too good, huh? I probably should double check if it's not
some cache trashing that was holding it back before), 28% - on
Alpha Linux and 12% - Solaris 7/64.

portability.
Submitted by: Lennart Bång

went down from 1050 to 921 cycles on Pentium II. I haven't checked the
figures on Pentium yet.

now and I'm putting it back to 'make test' later today.

on the command line for various utilities.

config file (change RAW to DER).

block.

DSA_METHOD to make it more consistent with RSA_METHOD.

In case of a restart, v[0] and v[1] were incorrectly initialised.
This was interpreted by ssl3_get_client_key_exchange as an RSA decryption
failure (don't ask me why) and caused it to create a _random_ master key
instead (even weirder), which obviously led to incorrect input to
ssl3_generate_master_secret and thus caused "block cipher pad is
wrong" error messages from ssl3_enc for the client's Finished message.
Arrgh.

support for encrypted content type in PKCS7_set_content().